Debugging skills and methods of large extrusion blow molding machine

Blowing machine debugging is blowing machine before the formal operation of production, must also be a very important step. The debugging effect of the machine will directly affect the production of blow molding machine and the quality of blow molding products. Especially the debugging of large hollow blow molding machine, because the production process of large hollow blow molding machine is much more complex, there are many places to control, therefore, this article will share with you the debugging skills and methods of large extrusion blow molding machine.

· Check the oil level of the hydraulic oil in the oil tank of the blow molding machine to ensure that the supply of hydraulic oil and lubricating oil is sufficient.

· Switch on the main power supply and the main switch on the control box.

· The blow molding machine should be started under the condition of no pressure in the hydraulic system. When should the pressure value be adjusted? Just adjust to normal pressure after the blow molding machine is started.

· Start the blow molding machine, and then stop immediately. The purpose of this operation is to check whether the running direction of the pump is correct. If the running direction is not correct, the power cord should be replaced immediately.

· Ensure that the cooling water of the cooling cylinder is smooth.

· Switch on the heating system and temperature regulation system.

· Before the blowmolding machine starts, the temperature of the hydraulic oil needs to reach a certain value, so it is necessary to preheat the hydraulic oil before starting. If the temperature of the hydraulic oil in the oil tank of the blowmolding machine is too low, the heater should be started immediately, as a large hollow blow molding machine is usually equipped with a special heater.

· The blow molding machine should be started under the condition of no pressure in the hydraulic system. After starting, adjust the system pressure of each pump to the standard pressure value. There are usually two parts of the pressure system in the large hollow blow molding machine, one is the die closing part, the other is the extruder unit, and each of the two units has a pressure vent valve. After the pump stops running, the pressure relief valve needs to be opened, and then closed when the pump is working.

· Adjust the position of all the stroke ups to make the activity template run smoothly.

· The surface of the mould and the contact surface with the machine template must be cleaned before installing the mould of the hollow blow molding machine, so as to avoid affecting the normal operation of the mould during the production of the machine.

· In the absence of raw materials for the blow molding machine, it is necessary to manually operate the machine for several times to observe whether the indicator light, travel switch and various actions are correct and sensitive, and check whether some small fastening parts are loose.

· Run the machine in semi-automatic and fully automatic mode respectively to check whether it runs smoothly.

The above is about the debugging skills and methods of large hollow blow molding machine. In a word, the debugging of blow molding machine is a key step before the production of blow molding machine. HUAN MACHINERY is a large-scale manufacturer of hollow blow molding machine. It not only provides customers with machinery, but also provides a series of after-sales services such as installation, debugging and training. Of course, we have also prepared some technical articles and industry news related to blow molding machines, hoping to help you.