How to operate the extrusion blow molding machine

The operation process of the extrusion blow molding machine, as an important plastic product production equipment in the modern industry, the blow molding machine is a detailed introduction to the operating procedures of the blow molding machine.

I Operation process of blow molding machine

1. Turn the blow molding machine clockwise, the main power switch of the single-screw extruder, and rotate it from the horizontal state (OFF state) to the vertical state (ON state)

2. Press the green power button on the extruder control panel to start the extruder.

3. Press the blue reset button (R) on the control panel of the blow molding machine.

4. Turn the power switch on the control panel of the blow molding machine clockwise to turn it from the OFF position ( o ) to the ON position (| )

5. Set the temperature of each part of the extruder barrel on the extruder control panel.

6. Set the temperature of each part of the die on the control panel of the blow molding machine.

7. Set the parameters of each step of blow molding on the touch screen of the blow molding machine.

8. Add materials to the hopper of the extruder, and rotate the hopper to the feeding position.

9. After all parts reach the set temperature, wait about 15 minutes to make sure the temperature is stable.

10. Press the green start button on the extruder control panel to start the screw, rotate the screw speed control knob on the extruder control panel, and set the speed of the screw.

11. Press the green start button on the control panel of the blow molding machine to start the motor pump.

12. Turn the mode selection switch on the control panel of the blow molding machine to the fully automatic working mode.

13. After the material flowing out of the die reaches an appropriate length, press the green start button on the control panel of the blow molding machine to start the blowing cycle program.

II Close the blow molding machine

1. After the blowing cycle program is over, press the red stop button on the control panel of the blow molding machine to stop the motor pump.

2. Rotate the extruder hopper to the stop position.

3. After the material in the extruder barrel is emptied, rotate the screw speed control knob on the extruder control panel, set the speed of the extruder screw to zero, and press the red stop button on the extruder control panel. , stop the screw.

4. Turn the power switch on the control panel of the blow molding machine counterclockwise, and turn it from the on position (|) to the off position (o)